Coils of Plastic Tubing
Although these are the two most common techniques, both the electrofusion like the butt welding, are relatively simple, it is essential to prepare the surfaces on which we are going to do the join and to know in great detail the procedure to do a good welding.
At the moment of choosing what type of welding to use, we should take into account the type of work we are going to use, as regarding the reliability, both are similar systems. A factor that can result determinant at the moment of taking the decision is the flexibility of the PE pipes. With the butt welding it is better solve than with the electrofusion.
The main advantages of each of the procedures are the following:
It makes much easier the access when we have to weld in difficult situations or when we have little space to access the pipe.
We can join polyethylene materials of different generations and thicknesses without weaken the welding.
The cost of the installation is low, so it is very suitable to do it in private dwellings.
The welding equipment is, compared to the butt welding, cheaper and lighter, what allows moving it with ease.
It offers a wide range of solutions with simple power point and tapping saddle
Butt Welding Machine
It is possible to weld pipes with different generations of polyethylene.
It is simple to eliminate the rusted layer, an essential step to do the join with guarantees.
Through the removal of the melted material it is produced a self-cleaning of the welding.
It doesn`t need additional fittings for joining, what simplifies the procedure.
In pipes with a diameter higher to 200 millimetres is more efficient and economical.
The pipe can be bended with ease without increasing imperatively the tension of the whole installation.
The axial alignment and the round of the pipes are simple.